New Page 1

NEW ITEMS

See the Koger Company website, makers of the Koger Sunshade, and the Koger Wheel Chock

***NEW*** CRAFTLINE TOOL CHEST

Holds our "Complete Tool Kit" including large items such as the rivet gun and pneumatic squeezer.
Small enough to take to the airport when the plane is ready.
Partitioned top till holds lift-out tray with divider included.
Key locks both the top lid and drawers.
Full extension roller bearings on bottom three drawers.
Full extension friction slides on top three drawers.
Steel construction with Aluminum anodized handles.
Dimensions: 26" W x 12" D x 15" H 48lbs.
6 Drawers: 3 - 6.7" x 10.5" x 1.6" 2 - 22.5" x 10.5" x 1.6" 1 - 22.5" x 10.5" x 2.5"
IF ORDERED WITH THE EMPKIT OR COMPKIT - 5% DISCOUNT OFF $141.00
Additional shipping applies $10 - $27 depending on location

WWR-4 - Washer Wrench Set of 4 - $43.00

Complete set consists
of 4 wrenches with
8 different sizes

Wrenches are made of 301 full hard stainless steel AMS 5519

Wrenches will not rust and will always maintain their rigidity and tension.

Precision cut

Washers snap into position and are held firmly.

Convenient pouch

Helps organize wrenches in one location.

Wrenches are 0.042 thick

Wrench thickness is less than most washers, allowing easier insertion without obstruction.

Over 90% of all washers on an aircraft will fit in these wrenches!

HM12 - Hingemate Bolt Insertion Tool -   $29.00         SEE IT IN MOTION! 12min download @ 33K

Works for elevator, rudder, and aileron hinge pin insertion as well as other awkward applications.

3/16" bolt size and 1/4" bolt size on opposite ends of tool.

Made in Australia.

RLG11 - RIVET LENGTH GAUGE - $6.50

Gauge measures -3,-4,-5,&-6 rivets.

Used to check for proper length of rivets BEFORE setting.

Eliminates guessing if your rivets are properly set.

Works for both universal head and flush rivets. Precision machined to size from 2024 aluminum.

Rivets sizes permanently stamped. Gold anodized finish. Instructions included.

RLG4 - SHOP HEAD RIVET GAUGE SET - $15.00

Set of four gauges measures -3,-4,-5,&-6 rivets.

Each gauge measures minimum height and diameter of shop heads.

Eliminates guessing if your rivets are properly set.

Works for both universal head and flush rivets. Precision machined to size from 2024 aluminum.

Rivets sizes permanently stamped. Gold anodized finish. Instructions included.

NPJ4 - PLATE NUT DRILL JIG #4 SCREW -   $45.00

Perfect for wingtips!
Designed for accurate drilling of rivet holes for K1000 & K1100 plate nuts.
Flexible handle to provide hand clearance when jig is in use.
First drill clearance hole for the screw, insert tool in hole and drill first rivet.
Flip tool over, insert both pilots and drill the final hole.

AMP WIRE TERMINALS

Wrenches are made of 301 full hard stainless steel AMS 5519		Wrenches will not rust and will always maintain their rigidity and tension.
Precision cut		Washers snap into position and are held firmly.
Convenient pouch		Helps organize wrenches in one location.
Wrenches are 0.042 thick		Wrench thickness is less than most washers, allowing easier insertion without obstruction.