DIES & SETS
TO CHECK OUT OUR DIMPLE DIES & SETS KIT
CLICK HERE 
Our well know dimple dies are famous for providing you with
a crisp dimple that really fits the hardware perfectly. We set out designing
the dies with the idea that if they were made exactly correct the results
would be impressive, and we were right. The dies we manufacture are far
and again the best dimple dies you will find anywhere. The springback surfaces
of the die ensure that the skins will come out flat after dimpling and riveting.
The correct size and shape of the funnel make the rivets or screws sit flush
with the skin... not too high or too low. The stainless construction allows
the dies to be very hard without the risk of breakage. This ensures they
will stay correctly shaped and polished.
- Made on precision CNC lathe capable of holding .00003" tolerances.
- Made with stainless steel and heat treated to Rockwell 43.
- Will not create "dish pans" in the skin around the dimple.
- Polished to mirror finish.
- If they ever wear out or break (use in rivet gun exempt) we will replace
them free of charge.
- Small diameter female dies allow dimpling in close quarters such as
when a hold has been drilled too close to a flange.
- Use only with our 3/32" male die or the dies may stick
together.
- Small diameter female dies allow dimpling in close quarters such as
when a hold has been drilled too close to a flange.
- Use only with our 1/8" male die or the dies may stick together.
- Tank dies make deeper dimples to allow for the layer of tank sealer
between the rivet and the skin.
- Rivets will sit flush with the top of the skin and you will not have
to shave them off.
-
- This is what you need for tight spots.
- Put mandrel through female die and through the hole from the back of
the skin.
- Put male die over mandrel and squeeze using a standard pop rivet gun.
- Fit standard 120 degree pop rivets with 1/8" shank.
- Drill #40 hole and use 3/32" cleko
- Die pilot works in #40 hole
- Drill #30 hole and use 1/8" cleko
- Drill out with #28 drill for die pilot at time of dimpling
- Drill #30 hole and use 1/8" cleko
- Drill out with #19 drill for die pilot at time of dimpling
- Drill 3/16" hole and use 3/16" cleko
- Drill out with #10 drill for die pilot at time of dimpling
- All have .187" shank.
- All have 3/16" dia. shank
- Keep you dies, flat sets, and cupped sets organized and handy.
- Hardened washers
- Used in combinations to shim dies and sets to achieve desired results
when using a Pneumatic Squeezer.
- 2 each: .005" .015" .032"
