CUTTING TOOLS
- The original Adel Nibbling Tool notches and trims steel up to .0475"
thick and aluminum up to .0625" thick.
- Start with a 7/16" hole then use the nibbler to cut to the size
and shape desired.
- 3" cut-off disc used for cutting thin walled tubing, sheet metal,
fiberglass or for slotting applications.
- Maximum 23,000 rpm.
- Mandrel for holding cut-off disc in die grinder.
- 2-1/2" x 1/4" shank.
- Slotted locking screw permits wheels to work close to adjacent surface.
- *CHECK OUT OUR DIE GRINDER KIT ON THE "TOOL PACKS" PAGE*
-
- Sioux Tools' Force 2000 Series are very high quality imported tools.
- Superior gear and bearing quality.
- Manufactured to professional standards.
- Angled head allows maximum clearance for most cuts.
- Ball bearing construction for vibration-free operation.
- Precision machined steel gears for durability.
- Compact design for working in confined areas.
- Straight Model of grinder above.
- Taylor brand.
- Angled head allows maximum clearance for most cuts.
- Ball bearing construction for vibration-free operation.
- Precision machined steel gears for durability.
- Compact design for working in confined areas.
- Straight Model of grinder above.
- Single cutting edge creates perfectly round holes in metal, plastic
and other thin materials.
- Constructed of high speed molybalenum steel, heat treated and tempered
for long life.
- Perfect for drilling grommet holes when installing wire, control cables
or antenna leads.
- Made for cutting materials up to 1/4" thick.
- Cuts very clean holes in flat stock or round tubes.
- Built in slug ejector.
- Sizes include: 5/16" 3/8" 7/16" 1/2" 9/16"
5/8" 3/4"
- Similar to standard hole saws but very sharp teeth designed to "mill"
crisp holes.
- All produce very clean holes.
- Sizes: 7/8" 1 1/8" 1 3/8" cutters will cut 1/8"
deep.
- Sizes: 1 3/4" 2" 2 1/2" cutter will cut 3/16" deep.
- Steel template for locating and drilling holes for instrument mounting
screws.
- Centers itself in instrument hole cut-out.
- Template has hole patterns for both 3-1/8" and 2-1/4" standard
instruments.
- Tool for cutting perfect holes in your instrument panel for 3-1/8"
or 2-1/4" standard instruments.
- Begin with 5/8" guide hole for centering bolt and tighten the
nut until hole is cut.
- Tool cuts large holes with one face of discs, small holes with the
other.
- With a capacity of 1 3/4" to 8", the fly cutter is used for
cutting lightening holes in ribs and spars.
- The 1/2" shank is to be used only in a drill press and cuts best
at low RPM.
- The use of cutting fluid helps produce smooth clean edges
on aluminum.